The CISS installation instructions with inner liner. The inner liner in the printer has many advantages: the cable doesn’t lean over and knocking on the cover, it doesn’t prevent the print head to move, the cover is closed tightly (the dust gets inside the printer with the open cover of the printer). The disadvantage is: difficult installation process and replacement to a new CISS. .
The inner lining of the CISS prefer people who are professionally engaged in photography. Epson Stylus Office B42WD designed for the high-speed printing of text and images. Three rows of black nozzles allow you to print the "test page" for 5 seconds, the printer also print the color pictures and photos. The pigment ink will not be washed off. As a result, you get like Figure 1.
Figure 1.
Proceed to disassemble the printer. Remove the front cover, for this pry off the triggers (Figure 2).
Figure 2.
Unbolt the 5 bolts (Figure 3); remove the button bar and unplugging the ribbon cable (Figure 4). Remove the upper cup, to it pry off the triggers.
Figure 3.
Figure 4.
Disassemble is complete.
Fist you need to move the waste ink absorber.
We will install the CISS as shown in Figure 5.
Figure 5.
Fist you need to move the waste ink absorber. During the cleaning the inks run into the absorber (the sponge up is under the printer). We take out the absorber and lengthen it (Figure 6).
Figure 6.
The cables will be puss out through the holes on the side of the printer. It is better to build and install a CISS, and then pumped the CISS with the ink, although it’s possible as we did. Take apart the cables from donors and pass it through the side cover (Figure 7).
Figure 7.
Fasten the cable to the printer as shown in Figure 8. The cable has to be tightened, the carriage should move free from the right to the left edge (Figure 9).
Figure 8.
Figure 9.
Put on the upper cap of the printer, tighten the cables. Outputs are shown in Figure 10.
Put on the button bar, connecting the ribbon cable; fasten the five bolts and put on the front cover. The printer is ready. Now we need to pump out the CISS with the ink. How this is done you can see in this article.
Make some cleaning, if you've the problems with prints you can see the article Epson with CISS: basic troubleshooting.