Printer Epson Stylus Photo PX730WD, or its American analogue Epson Artisan 730 are widespread among people who are professionally printed the photos. As time passed, any printer requires servicing, or reset the waste ink absorber. Epson 730 is no exception, you need to reset the counter and replace the filler that absorbs all the ink. You can do the reset by using a special program in the service center, including ours. This article will show you how to servicing the Epson 730. We will not change the filler, but we’ll extend a tube through which the ink flows into the absorber, and remove it out into a jar.
In order to get to the filler, you have to unbolt a bolt (Figure 1).
Figure 1.
Next, lift the printer and pry off the unit of waste ink (Figure 2).
Figure 2.
Carefully remove the block and see the tube through which the ink is coming into the absorber, and absorber itself (Figures 3, 4).
Figure 3.
Figure 4.
Take out the absorber and changing it to a new one or washed it under the running water and dried (or do as we did, threw away the absorber). Lengthen the tube for the ink by using the cable and glue. Made in the body a hole and pass the cable through it (Figure 5).
Figure 5.
Carefully insert the unit of the waste ink into it and after it look that the cable has not been pinched, fasten the bolt on it place (Figure 6).
Figure 6.
If you will follow these instructions than then the ink will pour into a jar. You will need poured the ink periodically.