Manual for firmware Xerox WC-3215 / WC-3225 (USB)
Attention!
Make sure the FIX version of firmware is available for order in the generator that is compatible with the current version of the printer firmware.
Link for order reset Xerox Worcenter 3225 / 3215
Successful firmware can only be guaranteed with original chip in the cartridge!
When ordering it is recommended to select Upd (updateable) version FIX firmware.
Print report Xerox WC-3215 / WC-3225
Attention!
Report printing is not possible if the printer is blocked!
-From the menu:
On the printer control panel, press the Machine Status button [ i ] after that [ OK ].
Pressing the [ Ў ] to select a section { Configuration } or { Supplies Info}.
Press [ OK ] [ OK ].
Will print the appropriate report.
-From the service menu:
Enter the section { Diagnostics }, then { Report }
select { Configuration } or { Supplies Info}.
-The entrance to the service menu (TECH MODE)
Click: [ Menu ] [ # ] [ 1 ] [ 9 ] [ 3 ] [ 4 ] [ OK ]
-Using Easy Printer Manager and CentreWare Internet Services
Printing of reports possible using utility Xerox Easy Printer Manager
(installed by default with the printer driver).
Necessary order information fix-firmware is also available through the embedded web interface CentreWare Internet Services
(for details, see the printer user's guide).
The entrance to the forced flashing mode
When the printer is off, press and hold the yellow button: [ Clear All ].
Press and hold the [ POWER] button, after ~ 1 sec, release both buttons and quickly again press the button [ Clear All ].
When log in is successful in enforcing mode, the message on the display of the MFP { Download Mode. Press Stop Key } changes to { Wait Image }
-Procedure for firmware Xerox WC-3215 / WC-3225
Perform all the actions in enforcing mode.
Xerox 3225 and 3215
The firmware is done in 3 stages. Do everything carefully and carefully!
1. First you need to update the printer with a special original firmware.
We launch this firmware in the forced mode (Waite image should appear.)
(Below there is an instruction on how to enter the forced mode)
Download link http://www.korotron-files.com/s/5d87665eb0e44ed688281c3aab71125d
2. Enable the update to update the firmware by clicking on the machine itself:
MENU # 1934-OK-DIAGNOSTIC-DATA SETUP-F / W UPGRADE ON
Then update the firmware from the archive First_WC3225_V3.50.01.08.hd
We are waiting for the machine to be sewn.
3. Again go into the forced mode (should appear Waite image.).
And then update the firmware fix from FIX_XXXXXXXXXX_Second_WC3225_V3.50.01.08.hd archive
Wait until the machine is sewn
After the firmware, we stick the chips and do not allow the installation of other chips.
How to enter Xerox WorkCentre Forced Mode:
On the Xerox WorkCentre 3215 off, press and hold the yellow "Clear all" button
Switch the machine on with the Power button
Release the Power button, then the yellow button "Clear All"
Press the yellow button "Clear all" again.
If successful, the entrance to the forced flash mode on the Xerox WorkCentre 3215 screen will display a Wait image.
Successful printing!
1 (orig_WC3225_V3.50.01.08) download
2 (First_WC3225_V3.50.01.08) download
3 (FIX_**********_Second_WC3225_V3.50.01.xx)
Attention!
After flashing remove the chip. Do not allow the installation of other chips.